Options- Sheeting and Translucent Panels

cladding-coloursSingle skin uninsulated panels  may be OK for garaging, but double skin insulated is best. Composite panels on walls may be appropriate, particularly for office areas.

Translucent sheets in GRP are cheap. It is best not to have them in the roof but as alternate panels all round the tops of the walls/doors. If they are used in the roof they should have galvanised wire mesh inside.

It is good practise to use masonry for the bottom 2.1m (7′) of wall to make windows and walk through doors easier to install.

In hot countries you should choose white or very light coloured sheeting.

Colourcoat Pvf2 (Polyester)

Vermillion Black Bahama Blue
Slate Grey Mountain Blue(grey/blue)
Alaska Grey Pinewood Green
Kalahari Oyster Glen
Metallic Silver

Colorcoat HPS200

White SC
Albatross SC
Meadowland SC
(very pale green)
Hamlet SC
(ghostly grey)
Wedgewood Blue SC(Cambridge
Moorland Green SC(pale green)
Goosewing Grey SC(medium grey) Solent Blue SC
(bright electric
Jade SC
(bright green)
Merlin Grey SC
(slate grey)
Ocean Blue SC
(dark navy)
Heritage Green SC(british racing
Black SC Saragasso SC
(midnight blue)
Olive Green SC
(army green)
Honesty SC
(pale cream)
Aztec Yellow SC
(vivid yellow)
Bamboo SC
(yellowy brown)
Mushroom SC
Saffron SC Petra SC
(pink stone)
Svelte Grey SC Tangerine Orange SC(vivid orange) Terracotta SC
(dark brick red)
Vandyke Brown SC(dark chocolate brown) Poppy Red SC
(bright red)
Burano SC

Colour swatch for guidance only – Actual colours may vary.

Insulating Materials

White foil faced foam sandwich insulating board

insulating boards
Polyisocyanurate foam insulating board with embossed foil to both surfaces – outer coloured white. Supported in a galavanized tee grid.

Class 1 & 0 Surface spread of flame. Also available in Class GF to meet F.O.C requirements.

Double skin with fibreglass insulation

Liner panel separated from outer sheet by galvanized steel spacer section. Insulated with glass fibre or mineral wool.

Composite sandwich panel

insulating boards
The outer profiled sheet is normally galvanized steel substrate, colour coated with plastisol, PvF2, Polyester or self galvanized finish as reqired.

The insulation core is an integral closed cellular rigid isocyanurate or eurethane foam with an average density of 35Kg/m3.

The inner embossed and ribbed lining sheet is normally 0.4mm thick galvanized steel substrate, which may be finished with an off-white colour coat, if required.


Sheeting, translucents and insulation panels for steel framed community, church buildings both traditional and modern.